OMT 315 model data and connection selection
BLINCE OMT 315 is a disc-distribution orbital motor configuration. Keep its own displacement row with the selected shaft and mounting rather than attaching an entire family operating range to one motor.
OMT 315 model data
| Model | Displacement cm3/rev | Continuous pressure differential MPa | Continuous torque N m | Maximum continuous speed rpm |
| OMT 315 | 326.3 | 20 | 950 | 380 |
Catalogue limits apply to the listed configurations. Maximum speed, torque and pressure are separate limits and are not a simultaneous operating point.
Comparing OMT 250 and OMT 315
OMT 250 lists 251.8 cm3/rev, 20 MPa continuous pressure differential, 730 Nm continuous torque and 500 rpm maximum continuous speed. OMT 315 lists 326.3 cm3/rev, 20 MPa, 950 Nm and 380 rpm. The comparison shows why displacement, pressure and speed must be read together.
Compare the required torque at the intended running speed with the selected model data. A larger displacement changes the flow needed for a target speed; it does not establish a proportional increase in continuous torque. The selected shaft version and the operating point still determine which catalogue data apply.
Flow and speed for OMT 315
As a calculated example, assume 25 L/min reaches the OMT 315 with 326.3 cm3/rev displacement. Ideal motor speed is flow x 1000 / displacement, giving 25 x 1000 / 326.3 = approximately 76.6 rpm before volumetric losses. This is a flow estimate, not a measured BLINCE performance point or confirmation that the motor can deliver rated torque at that speed.
Actual speed and available torque depend on the operating point, oil conditions and motor losses. Use the relevant curve, starting data and inlet and outlet conditions to complete the selection. If the machine needs very low speed or changes load rapidly, include that duty explicitly in the enquiry.
OMT 315 installation and ordering information
| Item | Details for the enquiry |
| Shaft | OMT 315 shaft profile diameter key or spline usable length and external loading |
| Mounting | Flange form pilot bolt pattern and available space |
| Oil ports | Connection type position and hose clearance from the approved drawing |
| Return and drain | Outlet pressure and the drain arrangement for the supplied motor |
| Duty point | Required starting torque running torque speed and available flow |
For a conveyor, brush or rotary assembly enquiry, state whether the motor connects directly or through a belt, sprocket or gearbox. Include the load on the output shaft and its position. These are machine-duty examples; the actual configuration must be reviewed for its own hydraulic and mechanical requirements.
Faq
What displacement is listed for OMT 315
The reviewed catalogue lists 326.3 cm3/rev for OMT 315. Use the geometric displacement for the matching configuration rather than assuming the model number is an exact displacement.
Can the highest OMT 315 torque and speed be combined
The table entries are limits or model-specific ratings, not a single performance point. Check the intended speed, pressure and load against the applicable operating curve and duty instructions.
Which details identify the OMT 315 replacement configuration
Send the full existing reference and nameplate photograph, the shaft and mounting drawing, port details and the working duty. Include control or brake connections if they are part of the existing assembly.
Request a configuration quotation for OMT 315
Send BLINCE the complete OMT 315 reference, quantity and installation drawing. Add the required starting torque, running speed, available flow and inlet and outlet pressures, together with the connection details that must be retained.
